This strainer is made of A36 carbon steel. A36 steel has good strength, plasticity and weldability, favorable cost and excellent machinability. It is suitable for non-corrosive media including water, air and oil under normal temperature and low pressure conditions.
It adopts Yshaped structure, consisting of body, filter screen, end cap and sealing components. The medium flows in from the inlet, solid contaminants are captured by the screen, and clean medium flows out from the outlet. The screen can be taken out for cleaning by removing the end cap for easy maintenance. It is available in a wide range of sizes with flange, threaded or butt-weld ends. It is commonly used in water supply & drainage, HVAC, general oil transmission and plant utility piping systems.








1. Raw Material InspectionRaw materials are A36 steel plates or bars. Verify material certificates, check chemical composition and mechanical properties, mark heat numbers for traceability.
2. CuttingCut blanks for body and end cap per drawing requirements, remove cutting burrs and scale, reserve machining allowance.
3. FormingForm the strainer body by rolling or forging, machine the Y-shaped flow channel to ensure smooth flow and low pressure loss.
4. Welding AssemblyWeld main seams and nozzles following A36 carbon steel welding procedure, remove welding slag after welding.
5. Stress Relief Heat Treatment (If Required)Carry out stress relief heat treatment to eliminate welding residual stress as required by drawings or customer specifications.
6. Precision MachiningCNC machining of flange faces, threads and end faces, control dimensional tolerance and flatness of sealing surfaces.
7. Filter Screen FabricationManufacture stainless steel filter screen according to required filtration accuracy, match with sealing gaskets.
8. Pre-assembly TestAssemble body, end cap, filter screen and gaskets, check smooth disassembly and fitting performance.
9. Hydrostatic TestConduct shell hydrostatic test in accordance with standards to check leakage on welds and sealing joints.
10. MarkingMark model, material A36, size and pressure class on the strainer body.
11. Surface TreatmentSandblasting for rust removal, apply anti-rust primer, top coat can be supplied as per order.
12. Final Inspection & Document PreparationRecheck appearance, dimension and test records, compile material certificates and hydrostatic test reports.
13. Packing and WarehousingProtective packing, separate storage with complete quality documents attached.